0 of 13 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 13 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Sorry, you have not passed this course test. A Score of 80% or higher is required to pass. Go back and study the video materials again then retake the test. You can view the questions and your selected answers and if your selection was correct or not below:
Congratulations! You have passed this course test! You can view the questions and your selected answers and if your selection was correct or not below:
Congratulations! You’ve passed this course test with a Perfect Score! Well Done! You can view the questions and your selected answers below if you’d like:
The B.A.R. (Browning Automatic Rifle) is an air cooled, gas operated, fully automatic rifle that utilizes a 20 round magazine to fire .30 caliber cartridges from an open bolt.
Which one of the statements below best describes the operation of the Browning 1918 rifle?
What returns the bolt assembly of a B.A.R. back to it forward position after the gun has been fired?
What part of a B.A.R. acts as a safety feature that blocks the trigger from being pulled rearward?
When does primary extraction begin on a B.A.R.?
What part retracts the firing pin from the bolt face after the B.A.R. has been fired?
After the first shot has been fired and the trigger continues to be held rearward, when the Browning 1918A2 rifle is set to fire in full rate auto mode (not the slow rate of fire), what prevents the sear release from being hit by the sear to allow continual fire?
What does the center leaf of the sear spring control?
After the first shot has been fired and the trigger continues to be held rearward, when the Browning 1918A2 rifle is set to fire in its slow rate of fire mode, what trips the sear (moves the sear out of its engagement with the sear notch in the slide) in order to fire the gun again?
Does the bolt/slide assembly lock to the rear on a B.A.R. after the last shot is fired and the magazine is empty?
On the semi-automatic Ohio Ordnance B.A.R., why are there two pins holding the trigger housing in place in the receiver?
The Ohio Ordnance B.A.R. utilizes a hammer spring to power the hammer.
How many slave pins should be used to disassemble and reassembly an Ohio Ordnance B.A.R.’s trigger group?